Unit UBS-2100E, Инструкция по эксплуатации

Страница: 6 / 14

statistics norms. Whether you are considered as underweight, normal, or overweight.
You can take this indication as a reference data of your condition.
NOTE:
Whenever pressing ‘SET’ button, turning on the unit for fresh operation, you can always go
through the same steps to verify or adjust all personal data and previous measured records, before
measuring for new records.
NORMAL WEIGHING SCALES OPERATION
To use as General Weighing Scales (Disregard of any parameter setting for Fat / Hydration /
Muscule %).
1. Turn on the unit by slightly tap on the lower right corner of the platform of the scales just step-
ping on. LCD will wake up and prompt to General Weighing Mode, showing ‘0.0 kg’.
2. Step on the scales gently (do not jump on the scales). As soon as you step on the scales, LCD
will immediately display incrementing digits till it stabilizes followed by flashes and then locked
digits, showing your weight value. After a few seconds, LCD will automatically shut down.
ERROR AND OTHER LCD MESSAGES
LCD may show occasionally error message ‘Err’. Simply turn off the unit for a brief moment, or
remove and re-install batteries as a total re-set. Then turn on again to resume operation.
1. All segments lit up unanimously: Indicating all segments performing correctly.
2. ‘Err’: Overload, or strain gauge sensor zero point too high beyond upper range.
3. ‘LO’: Main unit battery power running low.
4. ‘Err-h’: The computed Fat % rate too high above range of upper limit. Please watch your diet,
do more exersices.
5. ‘Err-L’: The computed Fat % rate too low below range of lower limit. Take good care of yourself,
watch your nutrition.
6. ‘C’: Re-test. Error exists, please re-test to get the correct results.
MAINTAINING AND CLEANING AND PROPER USAGE
1. Use a dry, soft fabric to clean the device, or take a lightly damp soft fabric with mild detergent
to wipe clean the device. Do not use strong chemical solution as alcohol, benzene for cleaning.
2. It could be slippery when the unit platform surface is wet, or semi-damp. Ensure the weighing
platform surface is dry before using for safety reason.
3. Always weight / use the same scales on a hard flat surface. Do not use on carpets, mats.
Remove the batteries if the scales is not going to be used for a long period of time.
4. Do not drop the device, or jump on the device when using. Avoid strong impact and sudden
shake as it is a precision measuring device. The construction is delicate and sensitive to all
unwanted external impact.
5. Do not insert any exterior objects into any openings on the unit.
6. Do not attempt to open the unit to fix and repair the unit. This will invalidate the guarantee.
7. If failed to turn on the unit, check whether batteries had been installed, or batteries power too
low. Insert or replace new batteries, or contact your dealer for consultation.
8. If there are some errors on the display or can not turn off for a long time, please take off the
batteries for about 3 seconds. Then encase them again to remove the soft fault.
9. Improper use of the scales unit for purpose other than normal weighing, or exposing the unit to
electro-magnetic wave which leads to loss of data will not be covered by our warranty / guaran-
tee, nor our company will be liable for any of such loss or mishap.
10. Our company will not be responsible for mis-use of the scales for other purpose that incurs
physical damages to the user or any other third party user.
REFERENCE INFORMATION
The evaluated body fat result is based on a standardized measuring method. It is calculated by a
correlated formula developed on basis of extensive scientific studies. The hydration contact in the
lean muscle affects measuring result. Individual habits and lifestyle will affect balance of hydration
level. Other factors, like following may affect hydration balance:
a. After a bath, readings can be lower.
b. After a meal or drinking readings can be higher.
ENGLISH
5
UBS-2100E Inst 12/9/08 5:24 PM Page 5