Fix the back plate with the four new
screws.
Do not overtighten the
screws!
Push the touch button until the yel-
low LED flashes for the second time
and the display shows “CAL”.
Push the button again and the display
shows “oPEn”. Push the button a
second time and two different ran-
domly generated 5 digit code appear
on the display.
Hasp replacement and calibration:
Push the rocker and unfeed the loose
end of the hasp.
Remove the bridge.
After the numbers “CLOSE” appears
on the display and the new hasp
ends must be inserted.
Remove the rocker and the hasp
completely.
When the calibration was successful
the display will show “donE”. If cali-
bration was unsuccessful the Display
will show “Error” and calibration will
start over.
1
2
3
4
Mount the back cover. Place all five
O-rings delivered with the battery.
Remove the back cover and the old
battey.
Use a replacement battery
from Unisto
While booting the display lights up.
Plug in the new battery and turn the
e-Guard to check the display.
Battery change:
Torx T8
10 SEK
Activate and deactivate Bluetooth
Touch the button for 5 seconds and
the green LED starts/stops flashing.
Operations (oPS)
Touch the button 5-times in 5
seconds. The total amount of opera-
tions is shown.
Device functions:
Firmware
Touch the button for 10 seconds until
the green LED flashes for the second
time.
Firmware version, for example
2.02.04.
10 SEK
5 SEK
5 SEK
5x
