Unison Research Unico CD Primo, Руководство пользователя

Страница: 18 / 31

18
START-UP
IMPORTANT! Switch on the Unico CDPrimo only after all the
connections have been checked.
Before switching on the
Unico CDPrimo
, make sure the amplifier volume
is at the minimum, and leave it in this position until the initial warm up of
the device is concluded.
The best audio quality is achieved about 10 minutes after the device has
been activated.
At the start up, the
Unico CDPrimo
performs a valves warm up procedure.
During this stage the outputs are disabled, in order to prevent needless
strain to the amplifier due to the transient signals that normally occur before
the tubes reach the working temperature.
This process takes about 30 seconds: during this time the unit displays the
message VALVE WARM UP and the counter digits.
During the warm up, about 10 seconds after switching on, the symbol is
displayed on the screen beside the counter digits: from this moment on it is
possible to command the opening and closing of the drawer mechanism
using the
EJECT
button on the remote handset or on the front panel.
After the warm up process, the CD eventually loaded is immediately ready
to be played.
LOADING A DISC
In case no disc is present on the tray after the warm up countdown ends, the
Unison Research
®
UN logo is displayed on the LCD display.
It is possible to open the CD drawer mechanism pushing the
EJECT
button
on the remote handset or on the front panel, insert a CD, and then close the
drawer pushing again the
EJECT
button.
Once the control of the CD content has been performed and the table of
contents has been read (the display shows the message LOADING), the
units is ready: the display shows the message
STOP , the total number of
the tracks and the total time of the recording.
In case the loaded disc doesn’t contain valid audio information, the display
shows the Unison Research
®
UN logo and the CD player stands by until the
user changes the disc.
IMPORTANT! Even though the Unico CDPrimo drawer mechanism
allows to be closed simply pushing it back, we highly recommend not to
force it: if done regularly, this could cause malfunctioning and damages.