ULA
PLANNING AND
ASSEMBLY
INSTALLATION MANUAL
INSTALLATION GUIDE
PAGE
10
Standard Series Clamps: Endclamp & First Module
INSTALL MODULE ENDCLAMPS:
The Endclamp is
supplied as an assembly with a T-bolt, serrated fl ange
nut, and washer. The washer retains the clamp at the
top of the assembly. This will enable the clamp to
remain upright for module installation.
INSTALL FIRST MODULE:
Install the fi rst end module
onto rails. Engage module frame with Endclamps.
Verify that the position indicator & T-bolt shaft are
angled in the correct position.
TORQUE VALUE 1/4” nuts to 10 ft-lbs. w/Anti Seize
NOTE: *See appendix for additional clamp confi gurations
POSITION INDICATOR - SERRATED T-BOLT:
Verify the
T-bolt position indicator is perpendicular to the rail.
INSERT ENDCLAMP T-BOLT:
Insert 1/4” T-bolt into
rail.
ROTATE ENDCLAMP T-BOLT:
Rotate T-bolt into
position. Verify that the position indicator & T-bolt
shaft are angled in the correct position.
End clamps are positioned on rails prior to the fi rst
end module and installed after the last end module.
