| 32
C64.65201 Issue 3
Jun 2019
Lift the door off its hinges (shown in green) by driving out both of the two part
hinge pins (shown in magenta below).
Once the door is off, using an 8mm socket, remove the 4 x rubber doorstops (shown
in red) fitted inside the door flange and retain.
Remove the hinge plates and then using the same dome nuts and washers
reposition the hinges to the opposite side of the door fitting them onto the studs
previously used for the rubber door stops. (Do not fully tighten at this stage to allow
later door / frame alignment).
Relocate the door stops to the studs previously used for the hinges.
