REPLACEMENT OF ASSEMBLIES - MTJ 40 ECO SERIES
Before any operation make sure that the module is disconnected from the power grid to prevent possible injuries
caused by the electrical current or moving parts.
STEP 1:
loosen the screws (highlighted in green).
STEP 2:
loosen the belt by unscrewing two screws
(highlighted in red) on each side. Count number of
turns the screws are screwed in (you will need it
when tensioning the belt).
Note:
if you wish to remove the belt completely
unscrew all eight screws.
Loosening the toothed belt
Removing the end blocks
STEP 1:
loosen and detach the toothed belt from
carriage
STEP 2:
loosen the screws attaching the end
block(s) to the profile.
STEP 3:
remove the end block(s).
1.145.0
MTJ MRJ Series
MANUAL
Note:
all screws (except set screws) must be glued (Loctite 243) and screwed with
the torque specified in the table on page 1.005.0 unless written otherwise at the
individual steps.
STEP 2
STEP 3
The specifications in order to improve the products in this catalogue are subject to change without notice.
