In order to improve the products in this catalogue the specifications are subject to change without notice.
MAINTENANCE AND ASSEMBLY INSTRUCTIONS / MCE AND MSCE MINI ELECTRIC CYLINDERS AND SLIDERS
MOUNTING
MCE
The attachments can be mounted as follows (see Figure 11):
1 – on the piston rod end
2 – on the guiding unit
Figure 11:
Mounting the attachments to the MCE.
Mounting the attachment
Never use other mounting points as it is presented
The attachments can be mounted only on the presented
points (see Figure 11 or 13), otherwise the product may
be damaged.
Avoid from collision of the mounting screws and the
product
There must never be any collision of the mounting
screws and the product, otherwise the product may be
damaged. The length of the mounting screws must be
selected properly.
Avoid from collision of the attachment and the product
There must never be any collision of the mounted
attachment and the product, otherwise the product
may be damaged.
For the mounting holes dimensions of the product and
accessories, please refer to the product catalogue MCE
and MSCE (mini electric cylinders and sliders).
The piston rod must not be subjected to torsion
when tightening or loosening the hex nut
In order to avoid torsion, use one wrench to hold the
piston rod in position, then tighten or loosen the hex
nut with the second wrench, see Figure 12. If the
attachment is fastened on the piston rod end using
the tapped mounting hole, please refer to Figure 9.
Figure 12:
Tightening and loosening the hex nut to mount
the attachment on the piston rod end.
