1. Working Environment.
1.1 The environment in which this welding equipment is installed must be
free of grinding dust, corrosive chemicals,
fl
ammable gas or materials etc, and at
no more than maximum of 80% humidity.
1.2 When using the machine outdoors protect the machine from direct sun light, rain
water and snow etc; the temperature of working environment should be
maintained within -10°C to +40°C.
1.3 Keep this equipment 30cm distant from the wall for ventilation.
1.4 Ensure the working environment is well ventilated.
2. Safety Tips.
2.1 Ventilation
This equipment is small-sized, compact in structure, and of excellent performance
in amperage output. The fan is used to dissipate heat generated by this
equipment during the welding operation.
Important:
Maintain good ventilation of the louvers of this equipment. The minimum distance
between this equipment and any other objects in or near the working area should
be 30 cm. Good ventilation is of critical importance for the normal performance
and service life of this equipment.
2.2 Thermal Overload protection.
Should the machine be used to an excessive level, or in high temperature
environment, poorly ventilated area or if the fan malfunctions the Thermal Over
load Switch will be activated and the machine will cease to operate. Under this
circumstance, leave the machine switched on to keep the built-in fan working to
bring down the temperature inside the equipment. The machine will be ready for
use again when the internal temperature reaches safe level.
2.3 Over-Voltage Supply
Regarding the power supply voltage range of the machine, please refer to “Main
parameter” table. This equipment is of automatic voltage compensation, which
enables the maintaining of the voltage range within the given range. In case that
the voltage of input power supply amperage exceeds the stipulated value, it is
possible to cause damage to the components of this equipment. Please ensure
your primary power supply is correct.
2.4
Do not come into contact with the output terminals while the machine is in
operation. An electric shock may possibly occur.
CAUTION
Page 15
Instruction Manual for MIG-TIG-MMA-500SWF (L591)
16/12/2014
