BEFORE USE/ FITTING
BATTERY CHARGING, FIGURE 6.
The system has a 100-240Volt, 1.5A battery charger. The battery can be charged when installed in the U21014K unit or separately.
WARNING: The battery can only be charged with supplied battery charger (Part No.P-06 03 001).
All new units must be charged before they are used for the first time.
The charger must not be used in any circumstances for any other purpose than for which it was manufactured. It is intended for indoor use (must be
protected from damp) and must not be used to charge non-rechargeable batteries.
The battery will be fully charged in about 3.5hours (also the heavy duty battery) this depends on residual capacity.
The red light goes on during battery charged and the light will turn green when it is full charged (FIGURE 7).
The battery will discharge during a long period in storage. For this reason, always re-charge the battery if it has been stored for more than 15 days. To
achieve maximum power when the battery is new, or has been stored for more than 3 months, charge and discharge the battery at least twice, remove
the battery out of the U21014K unit and store separately.
Points of attention:
1.
Check that the mains supply voltage to the charger is correct.
2.
Connect the battery charger to the wall socket.
3.
Connect the battery charger to the battery.
WARNING:
If the U21014K unit starts, switch it off while charging.
The battery icon on the U21014K unit is used for battery capacity instead of the charging state indicating (FIGURE 8). Always refer to charging light to
tell the charging state.
Recommended surrounding temperature at charging is between 0 to 40ºC.
FIGURE 7
FIGURE 6
FIGURE 8 (NOT FOR CHARGING STATE INDICATING)
FIGURE 9
FIGURE 10
10
| PAPR Welding Helmet Manual
PAPR WELDING HELMET
0432 PAPR Manual MAR21.indd 10
0432 PAPR Manual MAR21.indd 10
10/03/2021 2:19:52 PM
10/03/2021 2:19:52 PM
