Unilux 400110240, Руководство пользователя

Страница: 8 / 38

R’CLEAN air purifier
Timer function:
Press the TIMER button after the start or in the other mode, it will go into the timer
mode. In this mode you can set the specific time between 0,5-24 hrs to
automatically switch off the air purifier. The set time will be indicated on the
display.
Ions function:
Press the IONS button after startup or in others modes, the indicator will light
while anion generator releasing anions. Press the IONS button again the indicator
will light out and the anion generator stop releasing anions.
UV Lamp function:
Press the UV button after start up or in the others modes, the indicator will light
while the UV LED light. Press the UV button again, stop this function.
PM 2.5 Indicator function:
After start up, the PM 2.5 Indicator will flash, 30 seconds later, it will show the
indication of PM 2.5 detected by sensor.
Filters reset button function:
Press this button after start up, the display will show the residual life of filters
« % ». 3 seconds later, it will turn back.
When the filters needed to changed, this button will flash. After you have
replaced the filter, press this button for 5 seconds to reset
Care & Maintenance:
Before attempting to perform any maintenance on the purifier, disconect
the power adaptor
Filter: Suggested time of changing filter: about once a year
Cleanup routines : biweekly by using soft brush or dry cotton cloth to clean the
filter surface only. Do not use water to wash the filter
Sensor Cleaning:
1. Keep surface of the sensor
clean, or sensitivity is affected
and could fail to work.
2. Recommended cleaning cycle is
biweekly for regular use.
3. Clean the sensor with a cotton
swab as shown in the picture
below. Do not use detergent or
any liquid in the cleaning
process.
PM 2.5 sensor
Cylinder inner surface
cleaning
EN
7