Unika XT-Series, Инструкция пользователя

Страница: 6 / 20

Figure
2
page 5
13. Cooling Fans - Dual 2-speed cooling fans.
14. Input Gain Switch - This three position switch let you select different input
sensitivities, respectively three different voltage gain. The switch setting is
selectable at 26dB, 32dB or 0.775V input sensitivity for the XT-900 / XT-1250
and 0.775V / 1V / 1.44V selection for the XT-500 / XT-600.
15. Channel 2 Frequency Adjustment - This knob is used to adjust the
frequency level sent to your speaker on channel two when running the
channel in subwoofer mode.
16. Channel 2 Subwoofer Mode On/Off Switch - Turns the subwoofer mode
for channel two on and off.
17. Channel 2 XLR Input - Channel two 3 - pin XLR balanced input jack. See
page 7 for more details.
18. Channel 2 XLR THRU Jack - This jack is used to send a parallel signal from
the channel two input jacks to another device or amplifier.
19. Channel 1 XLR THRU Jack - This jack is used to send a parallel signal from
the channel one input jacks to another device or amplifier.
20. Channel 1 XLR input - Channel one 3 - pin XLR balanced input jack. See
page 7 for more details.
21. Channel 1 Subwoofer Mode On/Off Switch - Turns the subwoofer mode for
channel one on and off.
22. Channel 1 Frequency Adjustment - This knob is used to adjust the
frequency level sent to your speaker on channel one when running the
channel in subwoofer mode.
23. Mode Switch - This switch controls the amplifier’s operating mode. The
amplifier can operate in three different modes; Mono Bridge, Parallel Mono,
or Stereo. The amplifier is shipped in stereo mode.
24. Reset Button - This button is used to reset the breaker.
XT-500 / 600 Rear Panel Control
Safety Precautions | Introduction | Front Panel | | Set Up | Speakon Assembly | Operating Modes | Protection | Amplifier Features | Specifications
Rear Panel
0.775V 1.44V 1V
GAIN
INPUT
Made in Taiwan
PARALLEL
PUSH TO RESET
~220VAC 50Hz
BRIDGE
NORMAL STEREO
20Hz 200Hz
FREQUENCY
SUB
NORMAL
SUB
20Hz 200Hz
FREQUENCY
CH-2 CH-1
THRU THRU INPUT INPUT
CAUTION
MINIMUM LOAD IMPEDANCE
2 OHM PER CHANNEL
4 OHM BRIDGE
Serial No.:
H-2 C
1+ 1-
POS NEG
CH- 2
1+ 1-
POS NEG
BRIDGE
H-1 C
K
C
O
L
K
C
O
L
K
C
O
L
1+ 1-
POS NEG
CH- 1
LIFT
GROUND
input power less than 2000W
13 23
30 31 27 26 25
24 14 15 16 17 18 19 20 21 13 22
UNiKA XT-500 / XT-600 / XT-900 / XT-1250