Unika NA-13600, Инструкция пользователя

Страница: 7 / 18

Introduction Front Panel Rear Panel Speakon Assembly Operating Modes Protection Features Specifications
Set Up
INPUTS -
The
NA-13600/NA-17600/NA-21600
amplifier allows you to use two types of input connectors per channel, a XLR female jack for
balanced connections and a 1/4” TRS female jack that will accept balanced and unbalanced connectors. Use these connections to connect the
output signal from a mixer, cross-over or EQ to your NA-13
600/NA-17600/NA-21600
amplifiers. A balanced connection is recommended for
cable runs longer than 20ft. When constructing your own XLR cables follow the pin configuration described below for proper connections. For
cable runs shorter than 20ft., you may choose the 1/4” TS unbalanced input option. The 1/4” TS unbalanced input option may be more
convenient for most users due to the abundant supply of prefabricated cables available at your local audio dealer.You may use the two XLR
“Input Thru” jacks to jump a parallel connection to another amplifier or other device. For example: Connect a XLR cable to the input of channel
one. You may now connect a XLR cable from the channel one “Input Thru” jack to the input jack of another amplifier's channel one input. This
will reduce the use of “Y” cables.
OUTPUTS -
BINDING POST/BANANA PLUG: Connect your speakers to the binding post outputs on the rear of the amplifier. The speaker wire may be
connected by bare wire (directly connected, usually for permanent connections), banana plug, or spade connector. Connections are made to
channel one and channel two outputs for Stereo Mode or across the red terminals of channel one and channel two for Mono Bridge Mode.
IMPORTANT NOTICE: Although a speaker will operate with the positive and negative leads plugged into either terminal on the amplifier binding
post, be sure to plug the negative lead into the black terminal and positive lead into the red terminal. Ensuring proper polarity will avoid
speakers being out of phase that can cause a loss of bass response.
Figure
8
2 Hot (+data)
1
3
2
Male XLR Pin Configuration
Figure
5
1 Ground / Return / 0v
3 Negative (-data)
Balanced TRS 1/4” Plug
Hot (+)
Negative (-)
Ground/Shield
Figure 6
Unbalanced TS 1/4” Plug
Hot (+)
Negative (-)
Figure
7
page 6
SET UP
UNiKA NA-13600/NA-17600/NA-21600
BANANA PLUG: (Figure 8)
When connecting your speakers to the amplifier using banana plug, be sure that the red and black caps on the binding post
are completely screwed in. Insert the banana plug into the caps of the binding post, be sure that the banana plug is inserted
securely to avoid the risk of popping out