Unika NA-13600, Инструкция пользователя

Страница: 4 / 18

0 10 0 10
Channel
1
TPS2800
Sig Clip Prot
Limiter
on
-
20
-
10
- 5
Clip Prot Sig
on
Limiter
- 5 -
10
-
20
PROFESSIONAL STEREO AMPLIFIER
Channel
2
Stereo Bridge Parallel
NA-21600
UNiK A
Introduction Rear Panel Set Up Speakon Assembly Operating Modes Protection Features Specifications
Front Panel
NA-13600/NA-17600/NA-21600 FRONT PANEL
page 3
UNiKA NA-13600/NA-17600/NA-21600
1. Rack Mounting Ears - Two front panel mounting holes are provided on each
mounting ear.
2. Fan Inlet Grills and Filter - NA Series amplifiers are cooled by two rear-
mounted fans. Cool air from front grills is filtered and flows over the heatsinks
and exhausts to back side. Make sure these outlets remain clear to allow
unrestricted air flow.
3. UNiKA Logo and Model No - NA series have 3 types of 3U models NA-
13600 / NA-17600 / NA-21600.
4. Signal Indicators - These green and yellow LED’s will glow according to the
average signal output.
5. Clip Indicator - This red LED will begin to flash when the channel begins to
overload (clip), at this point the channel will begin to distort. Under heavy
clipping activity, lower the channel’s gain control to reduce the risk of damage
to your speakers and amplifier. This LED may glow when the unit has been
turned off, this is normal.
6. Protect Indicator - The red Protect LED will begin to glow when the channel goes
into protect mode. When the channel goes into protect mode all output for that
channel will turn off. This is to protect any speakers connected to the channel.
7. Function Indicators - These indicators detail the operating mode of the amplifier.
These LEDs will also function as a power indicator.
8 . Gain Control - This rotary knob is used to control the output signal level of the
channel . Turning the knob in clockwise direction will increase output signal level .
9 . Limiter Switch - This is used to activate the channel’s built in limiter . The limiter
reduces the average input level when the signal begins to distort , this process is
designed to reduce distortion and protect the speakers . See limiter at page 13 .
10 . AC Power Switch - This switch is used to control the unit ' s mains power .
Figure 1
2 6 5 4 3 7
8 9 10
1 3