Unika NA-13600, Инструкция пользователя

Страница: 5 / 18

25 24 2 2
11
23 27
11
~120V 60 Hz
4200 WATTS
26
PARALLEL
SPEAKON
1 + POS
1 - NEG
14 21 20 19 18 16 15 1 3 1 2 17
FUSE F 40A/120V
S
U
E
F
S U
E
F
S
U
E
F
Introduction Front Panel Set Up Speakon Assembly Operating Modes Protection Features Specifications
Rear Panel
Figure
2
page 4
NA-13600 REAR PANEL
UNiKA NA-13600/NA-17600/NA-21600
11. Fan Outlet Ports - Cooling air enters the amplifier through the front grills
and exhausts through the fans. Be sure not to block these ports when
installing the amplifier or other associated equipment. Air must flow
unimpeded through these ports.
12. Channel 2 Balanced 1/4" TRS & XLR Input Connectors - These
connectors accept input signals on balanced TRS and XLR input plugs. See
the figure 4 for information on polarity. Connectors for each channel are in
parallel; the unused connectors may be used for "loop through" connection
to other amplifiers.
XLR pin setting: Pin-3/signal Negative, Pin-2/signal Positive, Pin-1/Ground.
13. Channel 2 Subwoofer Mode On/Off Switch - Turns the subwoofer mode
for channel two on and off.
14. Channel 2 Frequency Adj. - This pot adjust the frequency level sent to your
speaker on channel two when using your amplifier in subwoofer mode.
15. Channel 1 Frequency Adj.- This pot adjust the frequency level sent to your
speaker on channel one when using your amplifier in subwoofer mode.
16. Channel 1 Subwoofer Mode On/Off Switch - Turns the subwoofer mode
for channel one on and off.
17. Channel 1 Balanced 1/4" TRS & XLR Input Connectors - These
connectors accept input signals on balanced TRS and XLR input plugs. See
the figure 4 for information on polarity. Connectors for each channel are in
parallel; the unused connectors may be used for "loop through" connection
to other amplifiers.
XLR pin setting: Pin-3/signal Negative, Pin-2/signal Positive, Pin-1/Ground.
18. Channel 2 XLR THRU Jack - This Jack is used to send a parallel signal
from the channel two input jack to another device or amplifier.
19. Mode Selection Switch - This recessed, three-position switch configures
the amplifier for Stereo, Parallel or Bridged Mode operation. Amplifiers are
factory-configured for Stereo Mode. See section on Mode Selection for more
information.
20. Channel 1 XLR THRU Jack - This Jack is used to send a parallel signal
from the channel one input jack to another device or amplifier.