Unika MX Series, Инструкция пользователя

Страница: 10 / 18

PARALLEL
STEREO
BRIDGE
SUB
WOOF
NORMAL
FREQUENCY
NORMAL
SUB
WOOF
FREQUENCY
20 Hz 20 Hz 200 Hz 200 Hz
INPUT BALANCE INPUT THRU
PUSH TO RESET
CAUTION:
MINIMUM LOAD IMPEDANCE 2 OHM PER CHANNEL, 4 OHM BRIDGE
BRIDGE
MONO
_
+
+ +
_
CH-1 CH-2
CH-2
CH-1
_
OUTPUTS
PINOUT
1+ 1-
POS NEG
CH- 2
PINOUT
2+ 2-
POS NEG
CH- 2
1+ 2+
POS NEG
BRIDG E
1+ 1-
POS NEG
CH- 1
CH-1 CH-2 CH-1 CH-2
GAIN
0.775V 1.44V 1V
OPERATING MODES
STEREO OPERATION :
Page 9/ Figure 17 and Figure 18 detail examples of typical stereo set-up. Connect your inputs into channels one and two of the
amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (fully
counter-clockwise). Turn your amplifier on. Turn your input source level up. Use your front gain controls to regulate the output volume. Be sure not to raise the
volume to the clip level, however an intermittent clip signal is acceptable.
page 9
Introduction Front Panel Rear Panel Set Up Speakon Assembly Protection Features Specifications
Operating Modes
Figure
18 MX-4500/5500/6500 TYPICAL STEREO OUTPUT CONNECTIONS
SPEAKERS
2 OHM MINIMUM
SPEAKERS
2 OHM MINIMUM
CH-1
Input CH-2
Input
UNiKA MX-3500/MX-4500/MX-5500/MX-6500
Figure
17 MX-3500 TYPICAL STEREO OUTPUT CONNECTIONS SPEAKERS
2 OHM MINIMUM
SPEAKERS
2 OHM MINIMUM
CH-1
Input
MX-3500
REAR PANEL
CH-2
Input
MX-4500/5500/6500
REAR PANEL
PARALLEL
STEREO
BRIDGE