unigreen
9
the same, the operator normally sits in the cab of the tractor.
During calibration and maintenance operations the operator will be working near
the machine at ground level (for all the calibration and maintenance operations
refer to the relevant chapters).
In case of operations that request the entry to parts of the machines located
at 1,5 mt. height ,it is advised to use a ladder at rule; the ladder shall be
positioned steady on a flat ground not yielding and with the machine at a
standstill and braked.
In some special models with controls above 1.5 metres there is a platform to
make these operations easier.
This platform must only be used with the machine stopped.
NOTE: Put the ladder back into the correct operating position after use,
securing it with the hook; make sure not to pinch or crush your hands during
these operations.
4.1.2 HAND WASHING TANKS
The sprayers are supplied with an auxiliary hand-washing tank with clean water
and a hand tap.
This tank must always be supplied with water and the inside must be clean so
you can wash any parts of the body that come into contact with the chemical
product used.
Never drink the liquid inside.
4.2
PRELIMINARY CHECKS
When you receive the machine, check that it is complete and no parts are
missing.
If there are any damaged parts, inform your local reseller or UNIGREEN
directly in good time.
When the machine is delivered, make sure you ask:
a)
that the machine is delivered with all of its parts fitted and that the fitting
meets the requisites in table N° 12 pag. 33-34. (This procedure is necessary
because for reasons of space during transportation the machine is often
delivered partially dismantled).
b)
that it is tested in your presence in particular checking:
=
that the suction filter and the inside of the tank are clean and free of work
residues.
=
that the connections are made correctly following the basic layout (FIG. N°
11).
=
that the hose clips and all the unions and connections are tightened
properly.
=
that any herbicide boom is mounted in the centre.
=
that all of the protective covers are fitted solidly to the machine, in particular
the protective cover of the power-takeoff of the pump.
= Check the proper tyres inflation (pressure are indicated on tyres)
4.3
TRANSPORTING AND MOVING THE MACHINE
Every time you have to lift the machine, before starting the operation, always
make sure the lifting gear and the relevant tools and equipment (cables,
hooks, etc..) are suitable for lifting the load and check the stability of the
same.
It is forbidden to unhook and move the machine with the tank full.
The dry weight of the machine at the maximum level of fitting and with all the
accessories allowed is stamped on the nameplate (Fig. 2); use slings and
lifting gear with a adequate load-bearing capacity.
Don’t stand the sprayer on soft ground or steep slopes.
Never lift or move the sprayers by hand if there is liquid in the tank. The
machine will weigh more and the movement of the liquid can change the centre
of gravity causing uncontrolled movements.
We recommend using slings as shown in the figure, the lifting points to use on
the machine are indicated with the relevant symbol.
Don’t lift the machine with the forks of a forklift truck because the machine can
tip over due to the overhanging weight of the booms.
Don’t pass or stand under the machine when it is being lifted.
This symbol identifies the
clean water tank on the
machine used to wash
your hands
This symbol
identifies the
coupling points of
the machine
Содержание Campo 11
Страница 27: ...unigreen 27...
