Unigas KTP1030, Руководство по установке, использованию и обслуживанию

Страница: 42 / 149

C.I.B. UNIGAS - M039207CB
42
Adjusting the ignition electrode
Important Note: check the ignition electrode after each removing of the combustion head.
Observe the values quoted on Fig. 32.
.
Replacing the ignition electrode
To replace the ignition electrode, proceed as follows:
1 remove the burner cover
2 disconnect the electrode (E) cable (CE);
3 remove the combustion head (see par. “Removing the combustion head”);
4 loose screw (B) that fasten the ignition electrode (E) to the burner pilot (P);
5 remove the electrode and replace it, referring to the values quoted on Fig. 32.
ATTENTION: avoid the ignition electrode to contact metallic parts (blast tube, head, etc.), otherwise the boiler’s operation
would be compromised. Check the electrode position after any intervention on the combustion head.
Fig. 30 - Detailed view of the diffuser with pilot
(P) and ignition elecctrode (E)
Fig. 31 - Detailed view of the combustion
head with pilot (P) and ignition elecctrode (E)
Fig. 32
ATTENTION: avoid the ignition electrode to contact metallic parts (blast tube, head, etc.), otherwise the boiler’s operation
would be compromised. Check the electrode position after any intervention on the combustion head.
E
P
E
P
5mm
P
E
==
P
E CE B