General
5)
Click “Activate”
It is also possible to select previous or factory default settings.
Disable the NetBIOS Service
The NETBIOS Service makes it possible to access the module with the NetBIOS name “elise-
XXXXXXXX”, where XXXXXXXX is the module key number.
The NetBIOS port is default enabled but can be disabled if needed for security reasons.
1)
Click “Configuration” on the start page.
2)
Select Other Settings > Advanced Configuration in the menu on the Configuration page.
3)
Select “IP Ports” under Security in the menu on the Advanced Configuration Page.
Figure 8: The Web Access Security Page
4)
Select “Disabled” in the drop down list.
5)
Click “Activate”.
Allow Fragmented TCP Packets
Fragmenting is when the IP protocol allows an IP packet to be broken apart into several smaller
packets, which then can be transmitted and reassembled at the final destination.
If the network has a MTU value lower than the default 1500 bytes, packets will be dropped if not
fragmenting is allowed. If fragmentation is allowed in the network the parameter needs to be en-
abled in the module.
1)
Click “Configuration” on the start page.
2)
Select Other Settings > Advanced Configuration in the menu on the Configuration page.
3)
Select “IP Ports” under Security in the menu on the Advanced Configuration page.
4)
Select “Enabled” in the Fragmented TCP packets (Caution advised) drop down list.
5)
Click “Activate”.
Certificates
Certificates are used to increase security by encryption. A self-signed digital certificate is created
during the first start-up. This certificate is issued for the module’s MAC address. A certificate can
also be imported or created in the module.
A31003-M2000-M105-01-76A9, 29/06/2020
16
Wireless Service Gateway WSG, Administrator Documentation
