6
Installation
Regulatory Compliance Statements (USA/
Canada only)
FCC Compliance Statements for USA
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause harmful interfe-
rence to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measu-
res:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
IC Requirements for Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B conforme á la norme NMB-003 du Canada.
Modifications
Changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Installation
• A fixed electrical installation must be done by an authorized electrician.
• Maximum five units may be connected in a fixed electrical installation.
• The unit shall be placed in a dry environment with a temperature range from
+5° C to + 40° C (41° F to 104° F).
• The unit shall be mounted to a vertical wall.
• The unit shall be mounted to concrete or plaster walls only.
• Avoid mounting the unit in a sunlit place. This can affect the charging capacity.
Delivery Includes
• Battery Pack Charger
• Power cord including IEC C14 connector (male)
• Inlet accessory kit, including cable support holders and screws
A suitable extension cord is needed to connect a single unit to a wall outlet, unless the C14 con-
nector is replaced (by an electrician). The following item can be ordered from Siemens Enterprise
Communications GmbH & Co. KG:
Item
Item Number
EU cord
L30280-Z600-F105
UK cord
L30280-Z600-F102
SWZ cord
L30280-Z600-F103
US cord
L30280-Z600-F101
