TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
27
5. Maintenance
The broken handset is replaced and its settings are transferred to the spare handset.
Replace and Move Licenses using WinPDM
The broken handset and the spare handset do not have the same device type and/or
have the same functionality license.
The spare handset must be an unlicensed WL3 to move the licenses to the spare
handset. To check that the handset is unlicensed, press *#34# in idle mode and select
“License“. Only WL3 must be displayed here.
1
Place the broken handset in the Desktop Programmer (DP1) cradle.
2
Open the WinPDM.
3
Make sure that the broken handset is saved in the WinPDM. In the Numbers tab,
a saved handset has the symbol
in the Saved column. If not, right-click the
handset and select “Save“ in order to transfer the settings to the spare handset
later on.
4
Place an unlicensed spare handset () in the Desktop Programmer (DP1) cradle.
5
Run the template with the basic network settings containing (see
4.5 Configure a
Handset with a Template
on page 14):
•
Network settings
1
(located under Network > Network A, B, C, or D)
•
VoIP settings
2
(located under VoIP)
The handset can be restarted depending on parameter changes.
6
Place the broken handset in the Desktop Programmer (DP1) cradle.
7
In the WinPDM, select the “Licenses“ tab.
8
Right-click the broken handset and select “Move license...“.
9
In the Move license window, select the WL3 that should receive the license.
Select “Do Nothing”. The broken handset restarts and has now become a WL3.
10
Place the spare handset in the Desktop Programmer (DP1) cradle. The spare
handset is restarted and the licenses for the broken handset in the WinPDM has
been transferred to the spare handset.
11
A Found Device Wizard window appears. Select “Associate with Number“ and
click “Next >“.
12
In the list, select the broken handset to be replaced with the spare handset. Click
“OK“.
The spare handset can be restarted and the settings for the broken handset in
the WinPDM are transferred to the spare handset.
5.3
Change Number of a Handset
It is possible to change the number of a handset, but keep all other settings in the
handset.
1
Open WinPDMor the Device ManagerWSG.
2
Open the Numbers tab, and select the handset to be updated with a new
number.
3
In the Number menu, select “Rename...“. Alternatively, right-click the handset
and select “Rename...” from the menu that appears.
4
In the New prefix field, enter the new prefix (if needed).
1. All required system settings for the WLAN. For example SSID and Security mode.
2. VoIP protocol, Gatekeeper IP address or SIP Proxy IP address used to access the PBX.