Coding keypad with alarm panel
Power-on
Preparation before usage
Close the lower cover and lock screws.
Install the batteries according to the battery
polarity direction indicated
As shown in picture, unscrew the screws
and open the base.
1.The keypad work with three AAA batteries.
Unscrew the screws , open the base and put batteries in keypad.
The keypad should be installed on the door or wall before usage.
Keypad installation
R
F
ID
Default user password:1111
.
Fix the setscrews on the door/window/wall
.
Buckle the keypad on the setscrews appropriately.
Assemble keypad well, tighten the screws
.
5
6
When alarm panel is under learning status, Arm/Disarm keypadl
twice, then you will see corresponding success feedback on the
alarm panel.(please refer to alarm system's user manual)
Note:
if the alarm panel make two sounds like “beep-beep” during coding,
this shows that the keypad have already coded with the alarm panel.
Note:
keypad will trigger tamper-switch alarm when you take down the
keypad, users can stop alarming of keypad by following disarm operations.
