UniFlow microMIND V2, Руководство по установке и настройке

Страница: 27 / 42

Firmware Update
microMINDs V2 delivered by NT-ware are always shipped with the latest firmware. If
you need a newer firmware for your microMINDs V2, please refer to the NT-ware
Knowledgebase where you will find the latest firmware.
There are two possibilities to update the microMIND V2 firmware.
Either through a USB stick (see
Firmware Update via USB Stick on page 15) or via
uniFLOW (see Firmware Update via uniFLOW on page 16).
Firmware Update via USB Stick
The microMIND V2 firmware can be updated with a normal USB stick.
Requirements:
▪ USB stick formatted with FAT or FAT32 and a sector size of 512 bytes. ▪
▪ New firmware with the file name MMAPP (note that the file name has no extension).
▪
Update process:
1. Format your USB stick according to the requirements listed above. 1.
2. Copy the MMAPP file onto the USB stick.
2.
3. Detach your microMIND V2 from the power supply. If PoE is used, detach the network
3.
connection.
4. Attach the USB stick to the microMIND V2. 4.
5. Attach the power supply. If PoE is used, attach the network connection.
5.
Update procedure: LED Status:
1. The device starts with the boot loader phase.
The microMIND V2 checks if a USB stick with valid firmware
is connected to the device.
Power LED: off
Status LED: orange
2. If no valid firmware is found, the device starts normally
(step 3. and 4. are skipped).
3. If valid firmware is found, it gets loaded.
4. Once the firmware has been loaded successfully, the Status
LED will flash green (approx. 4 sec.). Now you can unplug
the USB stick and reboot the device.
Power LED: off
Status LED: green flashing
5. Afterward, the microMIND V2 boots with the just uploaded
firmware.
15
Firmware Update
7
7.1