UniFlow Maxx Ice UIM225NB, Руководство по обслуживанию, установке и инструкция

Страница: 19 / 56

SERVICE AND INSTALLATION MANUAL
Page | 13
PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION
The machine doesn't
operate
The ice maker is unplugged Plug the ice maker in
The fuse is blown Replace fuse--if it happen, call for
service to check for a short circuit in
the ice maker
The ice maker power switch
is OFF Turn the ice maker power switch
to ON
The ice storage bin is full of ice Take away some ice, make the ice-
full sensor is free of ice
The water doesn't feed in
after the ice maker starts
The water supply tap is turn off Turn on the water supply tap
The water supply pipe is not
proper connected Reconnect the water supply pipe
Machine makes ice, but bin
does not fill up with ice
The condenser may be dirty Clean the condenser
The air flow to the ice maker
may be obstructed
Check the installation
The ambient temperature
and water temperature are
high, or it is near with some
heat resource Check the installation
Water is leaking out the unit
A few water drops to the
floor when you open the
door to take out ice from
ice storage bin
Normal condensation on the door or
some water together with ice Take
care when you take out ice
Water supply connection leaks Tighten fitting. See Connecting the
water line
Cubes are partially formed--
are white at the bottom Not enough water in
the water bin
Check if the water supply
pressure is below 15psig
Check water supply--filter may be
restricted
Check for a water leak at the water
tank
Noise during operation
The feet are not leveled See Leveling the Ice Maker
Certain sounds are normal See Normal Sounds
The icemaker stops suddenly
while making ice
The electricity is off Reconnected the power
supply line
The room temperature is out
the state range Cut off the electricity, let the ice
maker stop working till the tempera-
ture returns within the stated range
The body of the ice maker is
electrified
The earth line isn't in the socket Please use the socket meeting the
standard
Scales occur frequently inside
the machine The hardness of the water qual-
ity is too high Using a water-soften apparatus
installed in front of the water inlet
The ice cubes are not
completely formed when
being dumped The sprinkler is blocked Clean the sprinkler, see
"interior cleaning"
18
Troubleshooting Guide