SERVICE AND INSTALLATION MANUAL
Cleaning and Maintenance
WATER DISTRIBUTION TUBE CLEANING
When you find that the ice cubes are incompletely formed or the output of ice cubes is low, the water
distribution tube may be blocked Turn off the machine Unscrew the four screws holding the top panel
and remove the panel You will see the water distribution tube Rotate the water distribution tube so
that the holes in it are facing up Using a toothpick or similar tool, dredge the holes, then rotate the
water distribution tube back to its original position If the tube is badly blocked, clean it as follows:
1 Shut off the water and power supplies
2 Disconnect the water hose from the distribution tube
3 Gently take out the distribution tube
4 With a brush, clean the tube with a dilute solution of warm water and a mild detergent such as
dishwashing liquid After removing the dirt and lint from the surface, rinse the tube with clean water
5 Replace the distribution tube
6 Reconnect the water supply and power supply lines
7 Re-attach the top panel
ICE-MAKING SYSTEM CLEANING
Minerals that are removed from water during the freezing cycle will eventually form a hard, scaly
deposit in the water system Cleaning the system regularly helps remove the mineral scale buildup How
often you need to clean the system depends on how hard your water is or how effective your filtration
may be With hard water of 15 to 20 grains/ gallon (4 to 5 grains/liter), you may need to clean the system
as often as every 3 months
1 Press the ON/OFF button to turn off the machine
2 Remove all ice cubes from the storage bin If ice is being made, initiate harvest or wait for cycle
3 Keep the ice maker connected to the water supply Pour 8 oz of Nickel-Safe Ice Maker Cleaner
Solution into the water tank
4
Press the ON/OFF button to turn on the machine, the LCD screen lights Within 3 minutes,
press the CLEAN button The machine will run the automatic Clean mode
5 The cleaning cycle will continue for 30 minutes unless you press ON/OFF button(you can press the
power switch to stop the cleaning cycle any time during the 30 minutes) After cleaning, the LCD
6 The dirty water must be drained out completely Perform steps 2 and 3 in the Interior Cleaning section
7 Repeat steps 3 to 6 above three times to rinse the ice-making system completely NOTE: Do not add
Ice Maker Cleaner Solution to the water trough during the rinses
8 If you want to make ice cubes after cleaning, turn off the power switch, drain off the waste water,
then turn on the power switch The next ice-making cycle will begin
9. Discard the first batch of ice.
14
completion, then turn off the machine
screen will display the words of "OFF" The cleaning process stops
The ice machine cleaner contains acids DO NOT use or mix with any other
solvent-based cleaner product Use rubber gloves to protect hands
WARNING
CAUTION
Carefully read the material safety instructions on the container of the ice machine
cleaner DISCARD the first batch of ice produced after cleaning
CONDENSER CLEANING
The air-cooled condenser should be vacuumed
may have been drawn into it
1 Unplug the ice maker or disconnect power
2 Gently pull off the bottom louver
3 Romove dirt and lint from the condenser and
the air filter with brush attachment of a vacuum
4 Reassemble the air filter and the bottom louver
5 Plug in the ice maker or reconnect power
once or twice per year to remove any lint that
cleaner Use a pointed tool like a toothpick to
remove any lint that adheres to the condenser fins
Содержание Maxx Ice UIM225NB
Страница 56: ...NOTES REMARQUES NOTAS 55 PN 1866833100...
