20
10. Using the MOH output
The audio signal of the selected AUX source is available at the MOH output (43, 44).
8 Ohm output (43)
This outut can be used for a monitor speaker. The
outut power is 1W max.
1Vrms / 600 Ohms
output (44)
At this balanced outut an the Aux signal from the
a.m. source is available at a level of 1V (RMS).
Level of this output can be adjusted by ‚MOH Level’ control (42)
11. Operation of the Wall Panel UWC 8006
Remote Master
On / Off
UWC 8006
1
2
3
Sour ce
Aux Selec t
MIX Level
Li ne In
MI C
To UCX 8012
The wall panel UWC 8006 is connected via a RJ45 cable with the ‘WALL Panel’ connector (49) at the rear of the
UCA 8240.
The following functions can be remote controlled via the wall panel.
•
Zone selection zone 1 - zone 6
•
Selection of Aux source for BGM
•
Connection of a microphone
•
Connection of an audio source (i.e. MP3 Player)
Further information regarding configuration and/or operation of the UWC 8006 wall panel can be found in the UWC
8006 user manual.
Attention:
Audio signals being fed in via the wall panel have the same priority as the BGM signal from the UCA 8240.
