[ 50 ]
The message counter displays the number of messages stored in memory. If the display
flashes, then there are new messages waiting for you. The answering system plays your new
messages first. After you play all your new messages, you can then play your old messages.
Playing your messages
1) When the phone is in standby mode, press
play/stop
.
The system announces the number of new and old messages while the message counter
displays only the number of new messages. The time and day that each message was
received is announced after the message is played. The message counter will then
display the number of current stored messages.
2) When all new messages have been played, you hear a confirmation tone and the system
announces “End of messages.” The system returns to standby. After you have reviewed
your new messages, you can play your old messages by pressing
play/stop
again.
Once you have listened to a new message, it then becomes an old message. The old
messages will be played in the order in which they were received.
Repeating a message
1) Press
play/stop
to review your messages. The number of stored messages
is announced.
2) To repeat the current message, press
repeat/SELECT
after a few seconds of
beginning the message. To quickly scroll backwards through a message, press and hold
repeat/SELECT
.
To repeat the previous message, press
repeat/SELECT
within a few seconds (about 4
seconds during remote operation) after a message begins playing. If you have several
messages, press
repeat/SELECT
repeatedly until you return to the message you want
to replay. If the current message is the first new message, the system plays back from the
beginning of the current message (it does not go back into the old message group).
3) Press
play/stop
at any time to stop reviewing messages and return to standby.
The message counter shows the number of messages stored in memory.
• The time stamp will
not be heard until
you have set
the time.
• When the answering
system is full,
FL
appears on the base.
You should delete
some messages so
that the system can
record new messages.
(Refer to “Deleting a
message” on page 51.)
USING YOUR ANSWERING SYSTEM
UP388BH(WD3) OM 3/23/05 11:00 AM Page 50
Содержание WDECT 2355+3
