6
GETTING STARTED
The UWG700 comes included with mounting hardware, cables, AC adaptors and screwdriver with
security head. A Philips head and flat head screwdriver (not included) will also be required for
installation.
Mounting and Plugging in the Monitor
The monitor is able to be mounted on a wall using the wall mount or it can be rested on a table top using
the attached table stand.
Wall Mounting your Monitor
Choose a desired mounting location for the monitor station and
1.
fasten the mount using the included mounting hardware. Ensure
that the tabs (for sliding on the monitor) are facing outwards and
the hooks are pointing up.
Important: Make sure the mounting location is at an appropriate level
for you to access the buttons, easily view the LCD screen and is close
enough to a power source to be plugged in
Plug the jack of the small AC adaptor into the back of the monitor
2.
(labeled DC IN).
Note: Make sure to connect the smaller of the two AC adaptors to the
monitor - as a safety measure only the smaller AC adaptor will fit.
Plug the other end into a surge protected power source.
3.
Slide the monitor onto the wall mount by inserting the four tabs
4.
from the wall mount into the four slots on the back of the monitor.
Be sure to slide the monitor into place.
Hang Monitor Mount at
appropriate level
Plug Monitor in
UWG700 OM.indd 6
28/9/11 9:41:37 AM
