G E T T I N G S T A R T E D [ 1 0 ]
w w w . u n i d e n . c o m
3) Install the Alkaline batteries into the battery
compartment observing the correct polarity. Make sure
the outdoor temperature and humidity appear on the
base display within two or three minutes. If the outdoor
temperature and humidity don't appear, switch the
Channel
another channel and remove the batteries.
Install the batteries again.
4) Replace the cover and tighten the knob with a screwdriver
or a coin.
5) Place the handset in the base unit with the keypad
facing forward. Set up the outdoor sensor according to
page 7.
6) Make sure the
charge/in use
LED illuminates.
If the LED does not illuminate, check to see that the
AC adapter is plugged in and the handset makes good
contact with the base charging contacts.
Charge your handset at least 15-20 hours before
plugging into the phone line.
7) Once the handset battery pack is fully charged,
connect the telephone line cord to the
TEL LINE
jack and a telephone outlet.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
Modular
•Use only the Alkaline
batteries supplied with
your outdoor sensor.
•The base LCD will blink
and prompt you to set
the day and time. See
"Setting the Time" on
page 14 for the
instructions on how to
set the day and time.
•Once the outdoor
temperature and
humidity appear on
the base display, do
not change the
channel unless you
replace the batteries.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
!
GETTI
NG ST
AR
TED
CH07_Getting.fm Page 10 Wednesday, June 2, 2004 5:58 PM
