2
Registering the Handset to Another Base
To.register.a.handset.to.another.base:
Make.sure.the.handset.battery.is.fully.charged.
On.the.base,.disconnect.the.base.AC.adapter..Then.press.and.hold.
[find hs]
.while.you.reconnect.the.adapter..
Keep.pressing.
[find hs]
.until.the.
charge
.LED.starts.to.blink.
On.the.handset,.Press.
[Menu/Select]
..Select.the.REGISTER.BASE.menu..HANDSET.REGISTERING.will.
appear.in.the.display.
Wait.approximately.thirty.seconds..“REGISTRATION.COMPLETE”.will.be.displayed.to.indicate.the.handset.has.
been.registered.to.the.base.and.a.handset.ID.will.be.automatically.assigned.
If.REGISTRATION.FAILED.appears.in.the.LCD,.please.try.these.steps.again.
Selecting the Base
When.your.handset.is.registered.to.another.base,.it.will.automatically.connect.to.the.base..A.base.ID.(that.is.for.the.
handset.only).will.be.assigned.in.the.order.of.registration..You.can.either.select.a.base.you.want.to.use.manually,.or.
set.to.AUTO..If.you.set.to.AUTO,.when.the.handset.comes.out.of.range,.it.searches.automatically.the.available.base.
in.order.of.base.ID.
With.the.phone.in.standby,.press.
[Menu/Select]
..Select.the.HANDSET.SETUP.menu,.and.then.the.SELECT.
BASE.submenu.
Move.the.cursor.to.select.the.base.you.want.to.connect.to,.or.choose.AUTO.to.have.the.handset.automatically.
select.the.base.
Press.
[Menu/Select]
..SEARCHING.will.appear.in.the.display.
When.the.base.is.found,.the.handset.will.return.to.standby..If.the.base.is.not.found,.“SEARCHING”.continues.
to appear. You can repeat the procedure listed above to return back to the original connection or to find the
different.base.
Notes:.•.You.cannot.change.bases.during.a.call..
• To confirm which bases the handset is registered to, open the SELECT BASE submenu and use
[ ]
.and..
[ ]
.to.scroll.through.the.list..Press.
[ ]
.to.close.the.list.and.return.to.standby.
)
2)
3)
4)
)
2)
3)
4)