A D D I T I O N A L I N F O R M A T I O N [ 7 1 ]
w w w . u n i d e n . c o m
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code.
To change the digital security code:
1. Perform the "System Reset" menu options ("De-register the Handset" and
"Replacing the Base Setting") for all the handsets you have (see page 28).
2. To register all the handsets do the following steps:
1) Place a handset, one at a time in the base.
2) Registration starts automatically.
While registering
H an d se t R eg i st e ri ng
appears in the display.
3) When the registration is complete,
R eg i st r at i on C o mp l et e
appears in the display.
4) Repeat steps 1 - 3 for another handsets.
If the registration fails,
Registration Failed
appears in the display. Try the steps above again.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the holes.
Headset Installation
Your phone may be used with an optional headset, the HS 910 or HS
915. To use an optional headset, insert the headset plug into the
headset jack, and your phone is ready for hands-free conversations.
Headsets may be purchased by calling the Uniden Parts Department
at 1-800-554-3988 or by visiting
www.unide.com.
ADDITI
ONAL
IN
F
O
RM
A
T
I
O
N
UP323BH(DCT6485) OM ENG.book 71 ページ ２００３年１０月２４日 金曜日 午前１０時５６分
