UnicornHygienics Multivend, Техническое справочное руководство

Страница: 18 / 36

f) Take the new lock and turn it to its locked position and remove the key. Fit the new
lock into the door with the key tab cut-out at the top.
g) Refit the lock backing plate and large brass nut and tighten securely.
h) Refit the metal lock cam, ensuring that the lobe is to the left when looking at the back
of the door.
i) Refit the plastic cam, ensuring that it fits correctly into the locking bar fork. Replace
the small brass nut and tighten securely.
j) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational.
k) Ensure that the customer is given the two new keys.
3.4.12 Main door
See Fig 3-1 (10) and Fig 3-3 (10)
a) Disconnect the Motor Loom (Top and Bottom) from the Multivend Controller.
b) Remove and save the Power Pack, the coloured support structure and the main
window as described elsewhere.
c) Remove the self-adhesive tape securing the Motor Loom to the lower and upper
aspect of the door and coil the cable in the case.
d) Remove the ten screws retaining the Door to the Case - the door may now be
replaced.
e) Replace the main window, coloured support structure, and the Power Pack as
described elsewhere.
f) Refit the Motor Loom (Top and Bottom) to the Multivend Controller as before.
g) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational.
h) Ensure that the customer is given the two new keys.
3.4.13 Product flap and Security flap
See Fig 3-1 (6) and (7) and Fig 3-5 (6) and (7)
a) Product Flap - loosen the screws holding the right and left ends of the hinge pin and
slide the pin to the left. The Product Flap may now be removed and replaced. In a
Multivend dispenser also unhook the Security Flap wire.
b) Security Flap - Multivend dispensers
Remove the two screws holding the baseplate to the dispenser and unhook the Security
Flap wire. Replacement is the reverse procedure.
c) Replace and re-tighten the screws as necessary.
d) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational.