UnicornHygienics Multivend, Техническое справочное руководство

Страница: 15 / 36

c) Fit and screw in place a new Multivend Controller board and re-connect the five
connectors from step (a).
d) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational.
3.4.3 Motor loom
See Fig 3-1 (16)
a) Remove the cardboard chute infill.
b) Disconnect all the connectors to the shelf motors and remove the self-adhesive pads
holding the looms to the case right rear vertical corner area.
c) Disconnect the two 10-way connectors from the Multivend Controller board and
remove the looms.
d) Place the new looms in position, and re-connect all the shelves ensuring that the
connector polarising keyways are correctly inserted.
e) Fix the self-adhesive pads into the case right rear corner area to support the looms in
place.
f) Insert the two 10-way connectors into the Multivend Controller board.
g) Replace the cardboard chute infill.
h) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational.
3.4.4 Power pack
See Fig 3-1(12)
a) Remove the power pack connector from the Multivend Controller board.
b) Remove the Power Pack by pulling it upwards and outwards and replace with another.
c) Re-connect the Power Pack connector onto the Multivend Controller board.
d) Carry out the Machine Checking Procedure (Section 2) to ensure that the system is
fully operational
3.4.5 Coin track
See Fig 3-1 (9)
a) Remove the four lower screws holding the coin track cover, then remove the final top
screw fixing the coin tack bottom to the coloured support structure.
b) If there are any washers present between the coin track and the coloured support
structure on the two bottom screws, set them to the side and replace once
reassembling.
c) Replace the coin track bottom and cover and begin to screw the parts back onto the
support structure starting with the top screw working down to the bottom screws.