Unicorn ENDAT-3203M, Руководство пользователя

Страница: 48 / 60

42
The ENDAT-3203M/3220M System Board
The option settings can be changed, the table shown as below:
Option Default Setting Other Available Settings
Full-duplex Disabled

Auto Selection Enable – Forces to full duplex operation
Flow Control TX Enable, RX Enable TX Disable, RX Disable
Note:
Before setting the adapter for full duplex, make sure the hub switch is also set to full
duplex. Before you activate the switching hub to server connection, make sure the
hub switch and adapter are configured for full duplex.
3. Run Diagnostics
Running diagnostic tests perform basic function verification for on board LAN
adapters. The basic Diagnostic tests include:

EEPROM Test : EEPROM data read/write test

Diagnostics On Board : Performs on board basic function verification

Diagnostics On Network : To run this test on the network, you will need another
computer set up as a Responder to receive packets from the adapter being tested and echo
them back to the adapter. This checks the adapter’s ability for communication over the
network with another adapter to receive and transmit network packets.
4. Software Installation
Installing Network Drivers
You must install a network driver to allow the adapter to work with your network operating
system.
The system board provides various network drivers on the driver diskette. The following
provides the installation procedures for different network drivers.
Note:
Please install the “VIA PATCH FILE” first if you want to link your LAN with
Windows 98
For detailed information of each OS installation, please refer to the README (.TXT) file on
the driver diskette.