Unicorn ENDAT-3203M, Руководство пользователя

Страница: 47 / 60

User’s Manual
41
5-7. The Setup Program
The package includes a diskette containing the setup program. This program allows you to
verify the configuration and isolation of faults.
The adapter’s I/O port address and interrupt request levels (IRQ) are set by the BIOS. Other
default settings can be changed for situations as shown below.
Problem (RESET8139.exe) provides the following function:

Displays the current configuration of the adapter

Performs network diagnostic tests to verify the operation of the adapter’s basic
functions, and the adapter’s ability to communicate over the network with another
adapter.

Provides set up for new configuration to make a change specify settings: Flow Control
and Full-Duplex mode Enable/or Disable
Full duplex operation is set automatically if the Full-duplex option is set to Disable. Please
follow the prompt instructions to set-up or change the system configuration.
Note:
Before running the setup program, make sure the adapter’s driver is not loaded,
otherwise unpredictable results may arise!
The setup program can be set the on board configuration to provide diagnostic testing. It is
for testing the basic function verification, EEPROM data Access, loop back operation, and
the ability to communicate over the network with another adapter.
To access this program, insert the Driver Diskette into the floppy disk drive and then type the
following at the DOS prompt:

A:\REST8139.EXE <ENTER>
1. View Current Configuration
This allows you to find the PCI Fast Ethernet adapter current configuration in your
system.
2. Set Up New Configuration
Select Set Up New Configuration option from the main menu