7.
Disassembly & reassembly procedure
I. Removal of magnetic clutch
Tools required:
•
Stand
•
Clutch wrench
•
Torque wrench
•
M8 Socket
Procedure:
Place the compressor on the stand.
Hold clutch wrench by inserting the claws of the clutch
wrench into the holes on the armature
(3 points).
Remove the centre bolt by using the torque wrench.
Pull the armature upwards
II. Removal of snap ring
Tools required:
•
Snap ring pliers
(shaft)
Procedure:
Remove the snap ring by the snap ring pliers
as shown
III. Removal of pulley
Tools required:
•
Pulley remover
•
Standard wrench
•
Pulley remover pad
IV. Removal of coil
Tools required:
•
Standard screwdriver
Procedure:
Remove 3 M6 bolts with screwdriver
V. Inspection of magnetic clutch components
Armature -
Contact surfaces must be clean, smooth and
unmarked, with no abnormal scoring
Pulley
- As above. Ensure bearings run smoothly
Coil
- Wiring harness must be in good condition
Clutch
wrench
Armature
Shim
Snap ring
(+) Driver
Armature
Pulley
Coil
