31
EN
2. REMOTE CONTROL
2.6. R101 - Functions
TEMP
ON/OFF
O2 / AIR CLEAN
MODE
FAN SPEED
TURBO
SWING
SLEEP / ECONOMIC
AIR DIRECTION
RESET
TIMER ON/OFF
CANCEL
CLOCK
LOCK
LED DISPLAY
TEMP.
Button
▼: Press the button to decrease the indoor temperature setting.
TEMP. Button
▲: Press the button to increase the indoor temperature setting.
ON/OFF Button:
Push this button to start the unit operation. Push the button again to stop the unit operation.
O2 / AIR CLEAN:
Push this button to activate the oxygen generating mechanism, (if available), and the oxygen density of indoor
varies. To activate plasma filter (if available). Push again to stop the function.
MODE Select Button:
Each time you push the button, a mode is slelected in a sequence that goes from AUTO COOL DRY HEAT
and FAN, as the following figure indicates:
AUTO
FAN
COOL
DRY
HEAT
FAN SPEED Button:
SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO LOW MED
to HIGH, then back AUTO.
TURBO button:
Turbo is used for all the residential units. In cooling mode, when pressing the turbo button the remote controller
(if available), the unit will enter Turbo mode, with ultra-high speed and reach the set temperature more quickly (in this situation the
speed of Indoor fan will be higher that high speed level). After running 20 minutes in turbo mode, the indoor fan will automatically
recover the present speed. In heating mode, pressing this button will make nothing happen.
SWING Button
: Push this button, the louver would swing up and down automatically. Push again to stop it.
SLEEP / ECONOMIC Button:
Press this button to go into the Energy-Saving operation mode. Press the button again to cancel.
AIR DIRECTION Button
: Push this button, the louver can be fixed at a desired angle. The louver swing (upward or downward) to
a certain angle for each press. When the louver swing at an angle which could affect the cooling and heating efficiency of the air
conditioner, it would automatically change the swing direction (upward or downward).
RESET Button
: When the RESET button is pushed, all of the current settings are cancelled and the control will return to the initial
settings. (Use a 1mm little round stick to push the button.)
TIMER ON/OFF Button
: Push the TIMER button to set the switch on time. Push the TIMER button to set the switch off time.
CLOCK Button
: Push this button to set time.
LOCK Button
: Push this button to lock in all the current settings. To release settings, push again. (Use a 1 mm little round stick to
push this button.)
LED DISPLAY Button:
Led display is to switch on/off the display on indoor unit (if available). For example: in the night, people need
to sleep and do not want too much light, pressing this button will shut down the display and leave the room in dark (then in the mor-
ning, pressing this button will turn on again the display).
Содержание PS09 18HI
Страница 70: ......
