Unical .it AQ 15, Руководство по эксплуатации для пользователя

Страница: 6 / 16

6
To extinguish the heat stove
press the button for a few
seconds, until the upper
display reads “OFF”.
To adjust the room
temperature press the
button twice: the lower
display will show the words
"SET AIR" flashing, whereas
the set temperature is
shown on the upper display.
Use buttons and to
change the value.
The pellets will immediately stop dropping while
the heat stove will continue operating until the
accumulated heat is completely exhausted, and
go out after 30 minutes at the most.
PLEASE NOTE:
The heat stove is equipped
with an automatism to clean the
burn pot after a certain length
of time: when this happens the
flame is automatically lowered
and the display will read “PUL
FIRE”; after a few minutes the
heat stove will resume normal
operation.
Air temperature range: 7°C-40°C
ATTENTION!
To extinguish the heat stove, do not unplug
it but let the automatic extinction cycle end:
prolonged flue gas exhaust fan operation is
normal and may indicate that the stove is
still hot.
In case of low temperatures, moreover, flue
gas exhaust fan and circulating pump may
still start up for a few minutes with stove
off, in order to prevent possible formation
of ice in the system's pipes. In the event of
a power outage, when the power supply
is restored the heating controller will
expel the residual flue gas, increasing the
extractor's speed and displaying the words
“Cool FIRE”. Upon completing the cooling
cycle, the stove will restart automatically
and go back to the operating mode prior to
the power outage.
Heat stove extinction
Room temperature adjustment
Heat Stove Ignition