Unical .it AQ 15, Руководство по эксплуатации для пользователя

Страница: 4 / 16

4
Heat Stove Ignition
ATTENTION!
The burn pot must be cleaned before each
ignition.
Control panel (Fig. 2)
The button is used to ignite or extinguish the
heat stove and to quit programming.
The buttons and are used to adjust the
temperature, for programming display and
functions.
The buttons and are used to adjust the
heating power.
The button is used to set the temperature and
programming functions.
The upper and lower displays are used to view
the various messages.
Control panel signals
Before igniting the heat stove ensure the pellet
tank is filled, the combustion chamber is clean, the
glazed door is closed, the plug is plugged in and
the switch at the rear is in position “1”.
The LED is on when parameter
UT0 1 in the menu is other than
OFF, thus setting the weekly or
daily program.
ATTENTION!
It is recommended to use wooden pellets of
maximum 6 mm diameter, not moist.
Fig. 2
6
1
2
3
4
5
“SET”
LED SYMBOL DESCRIPTION
The LED is enabled every time
the pellets are being filled.
The LED flashes when the panel
receives a temperature/power
change signal from the infrared
remote control.
The LED is on when the room
temperature reaches the figure
set in the SET Water menu.
The LED flashes to signal that
the user/technician menu is
being accessed, or that the
temperature setting is being
modified.
The LED switches on when
the water circulation pump is in
operation.
1
2
3
4
5
6
Loading pellets into tank
Pellets are loaded into the tank through the specific
door at the back of the stove.
To load pellets, act as follows:
• Open the door at the top;
• Pour the desired amount of pellets into the tank,
with due care (pour enough pellets to guarantee
sufficient stove autonomy);
• Close the door.
LED SYMBOL DESCRIPTION