Using the machine
Please Note:
For best results spray guns should be cleaned as soon as
possible after use.
WARNING:
• THE LID IS LOCKED DURING OPERATION FOR YOUR SAFETY
• THE LOCK MUST NOT BE REMOVED
• TO UNLOCK SWITCH OFF THE MACHINE
Any paint left in cup/pot should be emptied into a waste container or stored for future use.
Place paint cup/pot into machine over the top pair of square nozzle jets.
The air cap of the spray gun can either be loosened or removed completely and put into machine.
Fit the trigger clip to trigger of spray gun. See Diagram 3.
Put spray gun into machine. See Diagram 4.
If using a suction spray gun fit directly onto taper nozzle
If using a gravity or pressure spray gun use a nozzle extension.
1
Close lid.
UGC4005 and UGC5005 ONLY
Ensure mode valve control lever is in the automatic position (horizontal).
Turn timer knob clockwise (The machine will run automatically for approximately 4 minutes).
Upon completion open the lid and remove the spray guns from the machine. We advise that you
DO NOT
store the spray guns in the machine.
MANUAL WASH/ CLEAN RINSE
UGC4005, UGC5005 and UGC2005M.
For UGC2005M Manual Wash and Clean Rinse begin this process at step two ‘Open lid of
machine’.
MANUAL WASH
Turn Mode Control Valve on the front of machine to Manual Mode.
Open lid of machine.
Turn Manual Wash lever to the ‘ON’ Position and clean solvent will flow from central block and
washing brush
Proceed to wash spray gun manually.
CLEAN RINSE
Repeat steps one and two listed above
Turn Clean Rinse lever to the ‘ON’ Position and clean water will flow from central block.
Rinse the spray gun.
6
7
8
9
1
2
3
4
1
2
3
2
3
4
5
a
b
