Unibor E3000, Руководство пользователя

Страница: 20 / 31

20
2 0
s
Pipe Adaptor Kit
FITTING INSTRUCTIONS
• Dependent upon the size of the pipe to be cut (see illustrations) attach adjustable angle plates RD3328
with cap screws RD4325 and washers RD4205 (4 off each) to the magnet sides. Do not tighten.
• Locate the machine on the center line of the pipe taking care that the magnet is in line with the
longitudinal axis of the pipe.
• Switch on the magnet and move the sliding plates down to the outside diameter of the pipe. Tighten
the screws on both sides by hand then check once again that the full length of the moving plates is
touching the pipe at the front and back, fasten the plate securely. Feed the safety strap through the
lugs at the front of the housing, around the pipe and pull tight.
•When cutting the hole DO NOT use excessive pressure but rather let the cutter ease into the cutting
surface.