Unibor BD35, Инструкция оператора

Страница: 8 / 16

Chapter 4. Maintenance Instructions
!
Occasionally apply a few drops of oil to the rack toothing.
!
The bearings of the feed shaft are self-lubricating and must not be greased
!
Grease the sliding surface of the carriage with MOLYCOTE grease.
!
When not in use or being transported the unit should be kept in the case supplied.
!
After use ensure unit is clean of swarf and dirt.
!
Parts that are worn or damaged should be replaced immediatley with original
MAGTRON replacements.
!
Ensure all cutting edges are sharp when in operation. Using blunt cutting tools may
lead to an overload of the motor.
!
After repeated use, the cradle may become loose.
This is remedied by adjusting the tension screws
on the side of the body. Put 2.5mm Allen Key into
head of cradle retaining nuts, using 8mm Spanner
undo the locking nuts anti-clockwise holding the
Allen key without moving grub screws.
Using the Allen Key gently tighten screws in series
until the cradle moves freely in the slide but does
not allow the motor to wobble.
When adjustment is complete re-tighten locking
nuts clockwise.
8