Unibor BD35, Инструкция оператора

Страница: 7 / 16

!
Energise the magnet.
Switch on the magnetic base by depressing the
YELLOW magnet switch.
CHECK that the pilot is still aligned with the hole
centre mark, as energising the magnetic base can
cause the machine to move.
!
Apply Coolant
A 500ml bottle of cutting oil is supplied with the machine. Using cutting oil can
increase the tool life and ensures that the slug is ejected cleanly.
Apply a generous amount of cutting oil to the surface to be cut.
If cutting surface is vertical or steeply inclined, then cutting paste, gel or foam should
be used.
!
Start Cutting
ALWAYS ENSURE THAT
CUTTING GUARDS ARE IN
PLACE.
Start the drill by depressing the
GREEN drill switch. Lower the
cutter to the surface by turning
the handle; and with light
pressure cut an initial groove. Increase pressure until
motor is loaded then maintain steady pressure until cut is
complete.
!
Finish Cutting
When the cut is complete the slug will be ejected from the cutter. Raise the cutter
again; stop the motor and switch of the magnet.
NOTE: –
!
Applying too much pressure will not speed the cut, it will reduce the life of the tool
and may cause damage to the motor.
!
If swarf becomes blue in colour then more cutting oil is required.
!
If the power is interrupted during the cut, the magnet must be reset before the motor
will restart.
7