7
/
78
trace line + state, measurement data, limit, correction and export.
System:
access to the system menu and set up the relevant parameters.
Default:
press it to reset the setting to the default.
TG:
the relevant setting of tracking source output terminal. Such as signal amplitude, amplitude
offset of tracking source. This key will light up when the trace source output is working.
Single:
press this key to perform single sweep. press it again to change it to continuous sweep.
Touch/Lock:
touch switch, press this key will indicate red light.
5. Data Controller:
direction key, rotary knob and numeric key, to adjust the parameter, such as
center frequency, start frequency, resolution bandwidth and make position.
Note
Esc
Key
: If the instrument is in remote control mode, press this key to return to local mode.
6. RF input 50Ω:
this port is used to connect the external input signal, the input impedance is
50Ω
（
N-Female connector
）
.
Warning
It is forbidden to load the input port with a signal that does not meet the rated value, and
ensure that the probe or other connected accessories are effectively grounded to avoid
equipment damage or abnormal function. RF IN port can only withstand an input signal power
of no more than +30dBm or a DC voltage input of 50V.
7. Gen Output 50Ω
（
Tracking Source
）
:
This N- Female connector is used to as the source output of
the built-
in tracking generator. The input impedance is 50Ω.
Warning
It is forbidden to load input signals on the output port to avoid damage or abnormal function.
8. Loudspeaker:
display analog demodulation signal and warning tone.
9. Headphone Jack:
3.5 mm.
10. USB Interface:
to connect external USB, keyboard and mouse.
11. ON/OFF Switch:
short press to active the spectrum analyzer. In on-state, short press ON/OFF
switch will change the state to standby mode, all function will also be off.
