Quick Start Guide UTS1000B/T Series
13
/
18
Instruments.uni-trend.com
The protection grade of this device is 4KV for contact discharge and 8KV for air
discharge.
Measurement
accessories
Measurement accessories are of lower class, which are definitely not applicable to main
power supply measurement, CAT II, CAT III or CAT IV circuit measurement.
Probe assemblies and accessories within the scope of IEC 61010-031, and current
sensors within the scope of IEC 61010-2-032 shall meet the requirements thereof.
Use the input /
output port of
this device
properly
Please use the input / output ports provided by this device in a properly manner. Do not
load any input signal at the output port of this device. Do not load any signal that does
not reach the rated value at the input port of this device. The probe or other connection
accessories should be effectively grounded to avoid product damage or abnormal
function. Please refer to the product manual for the rated value of the input / output
port of this device.
Power fuse
Please use power fuse of specified specification. If the fuse needs to be replaced, it
must be replaced with another one that meets the specified specifications (Class T,
rated current 5A, rated voltage 250V) by the maintenance personnel authorized by
UNI-T.
Disassembly
and cleaning
There are no components available to operators inside. Do not remove the protective
cover.
Maintenance must be carried out by qualified personnel.
Service
environment
This device should be used indoors in a clean and dry environment with ambient
temperature from 0
℃
to +40
℃
.
Do not use this device in explosive, dusty or humid air.
Do not operate
in humid
environment
Do not use this device in a humid environment to avoid the risk of internal short circuit
or electric shock.
Do not operate
in flammable
and explosive
environment
Do not use this device in a flammable and explosive environment to avoid product
damage or personal injury.
Caution
Abnormity
If this device may be faulty, please contact the authorized maintenance personnel of
UNI-T for testing. Any maintenance, adjustment or parts replacement must be done by
the relevant personnel of UNI-T.
Cooling
Do not block the ventilation holes at the side and back of this device;
Do not allow any external objects to enter this device via ventilation holes;
Please ensure adequate ventilation, and leave a gap of at least 15 cm on both sides, front
and back of this device.
Safe
transportation
Please transport this device safely to prevent it from sliding, which may damage the
buttons, knobs or interfaces on the instrument panel.
