Uni-Hydro PRO 56, Руководство пользователя, Страница: 10 / 73

PRO56 Uni-Hydro Manual
Page - 6 -
OPERATING INSTRUCTIONS (Cont)
1. Rest the material to be sheared on the base of the bar shear table.
2. To avoid distortion and avoid ironworker damage, firmly secure the bar holder onto the material to
be sheared.
3. Align the scribed mark with the outer edge of the bottom blade.
4. When making maximum cuts, position the material as close as possible to the apex of the throat
opening.
MAINTENANCE
CAUTION To prevent personal injury, disconnect electrical power to the ironworker before
performing maintenance procedures. Should power be required during maintenance, take
care to protect yourself and others from injury.
PUNCH INSTALLATION
1. Loosen two (2) 3/8” bolts and swing stripper to side. Remove punch jam nut, insert punch into
one (1) inch hole, replace the jam nut and tighten securely.
2. With indentation on the die aligned with the die stand Allen screw; tighten the side set screw with
an Allen wrench.
3. With stamped die size facing upwards, insert die into die holder and tighten the side set screw with
an Allen wrench.
4. Completely loosen 1/2 x 1-1/2 inch bolts (2) securing the die block.
5. Pull knob release button at top of punch plunger up and lower handle. Adjust punch block so
punch enters die and clearance is equal on all sides of the punch.
6. Tighten 1/2 x 1/2 inch bolts (2), install stripper and place punch adjustment handle in locked
position.
7. Operate ironworker to check punch and die alignment, correct if necessary.
DOUBLE LOCKING THE PUNCH
After alignment, punches can be double locked to prevent them from turning.
1. Run the punch into the die either manually with the manual punch aligner or by starting the
ironworker. Refer to Punch and Die Alignment procedure above.
2. Facing the punch, with the punch in the down position, locate a 3/8” NC threaded hole at the front
side of the exposed punch plunger. Part # 4213
3. Install a 3/8” x 3/8” set screw (not provided) to double lock the punch shank.