of transmitter, and then move the speakers to other free location. You can
re-adjust the tuning control by moving it either channel 1, 2 or 3 of the
transmitter, then pressing “SCAN” auto-tuning button for best reception.
TROUBLE SHOOTING
NO SOUND
Ensure the AC adaptor is fully inserted into the AC outlet and the
power connection input on the transmitter.
-
-
-
-
-
-
-
-
-
-
-
-
When transmitting / receiving over long distances, the signal from the
system will become weaker.
Ensure the speaker is switch ON.
SWITCHNG OFF
Speaker’s battery capacity is too low, replace with new batteries or
connect the AC adaptors to the speakers.
1.
Turn the VOLUME ON/OFF knob until the click sound is heard to turn
off the speaker and the LED light goes off
Ensure the TV or audio component is ON.
The connected audio / video equipment is not playing. Start
playing the equipment.
The volume of speaker is too low, adjust the volume to an
appropriate level.
DISTORTED
Press the “SCAN” button on the speakers until matching the
frequency of the transmitter.
2.
For protection of the transmitter and power saving, the transmitter will
cut off automatically if there is no/weak operation input signal from
audio source for 4 minutes.
Change the position of the channel selector on the transmitter.
You must then press the SCAN button on the speakers.
Battery capacity is too low. Replace with the new battery.
Ensure the volume level of speakers is adjusted properly.
In other words, if the signal comes back, the transmitter will work
again automatically.
The speaker is too far from transmitter, move closer.
The input level of the audio signal is too low. Turn up the
volume of the audio source equipment.
P.10
P.9
