UMAX AstraCam 1800 Owner's Guide
3
SETTING UP YOUR NEW DIGITAL CAMERA
Installing the Batteries
Important Battery Guides: Read Before Using the UMAX AstraCam 1800
Note: Improperly inserting the batteries (wrong polarity) may damage your
camera and will void the warranty. See the guide symbols inside the battery
case for proper installation of the batteries.
To put the batteries in the UMAX AstraCam 1800:
1.
Unwrap the 2 AA batteries. Note the
polarity symbols near the ends of each
battery.
2.
Open the battery cover at the bottom of
the camera by pushing the cover out with
your thumb.
3.
Note the +/- polarity symbols on the
contacts attached to the inside of the cover. Insert each battery so that the
polarity symbol of the exposed end of each battery matches the polarity
symbols on the contacts inside the battery compartment.
4.
Close the cover.
Replacing Worn-Out Batteries
Replace the batteries only with AA size, 1.5V batteries.
Inserting the SmartMedia Card
1.Open the panel on the right side of the camera.
2. Insert the SmartMedia card in (with the
metallic side facing toward the back of the
camera) until the card clicks into place. Pushing
on the center of the card again will release it to
pop out.
Caring for the SmartMedia Card
Store in a cool dry place and do not expose to moisture, extreme heat or
leave in direct sunlight. Do not use this media in any device that is can be
used to record or save audio sound files. Do not bend, fold or open the
SmartMedia cartridges.
