Ulvac PBL Series, Инструкция по эксплуатации

Страница: 38 / 47

26
In the case of AC200V, a power supply, please connect the conducting wire
of the heater and the connection to the terminal tandemly. Also, in the case
of AC100V, please connect it in parallel.( In case of PBL-02. )
5.3 Exchange the fluid
If the pump fails to give satisfactory performance on a leak tight system, inspect the condition
of the pump fluid. Use the following procedure.
①
Allow the pump to cool and open it to atmospheric pressure.
②
Disconnect the pump from the electrical supplies and detach it from your vacuum system.
③
You are careful not to hit a nozzle of the inside and pull it out.
④
PBL-02, PBL-04: The fluid drain from the pump.
（
PBL-06, PBL-10, PBL-14, PBL-20 :
Remove the drain-plug and allow the fluid to drain from the pump.
⑤
Wash the pump inside and a nozzle with solvents such as the alcohol well.
⑥
After washing, you dry a solvent enough.
⑦
After having assembled it again, you exhaust it with a roughing pump and remove
impurities such as a solvent, the water.
⑧
Allow the pump atmospheric pressure after the above-mentioned operation again, and a
quota pours fluid.
If this pump sucks in toxic gas, both the pump's main unit and the lubricant will
become toxic. Keep this in mind during maintenance.
Ask a waste disposal specialist to dispose of this pump if you have used it to
exhaust harmful gas that may endanger human health.
Ask a waste disposal specialist to dispose of this pump if you have used it to exhaust
harmful gas that may endanger human health.
Wear protective equipment, such as rubber gloves, proactive goggle and so on.
Should the oil touched to your hand are entered in your eye, immediately follow the
emergency treatment described on the SDS
Obtain and carefully read the safety data sheet (SDS) before using this pump.
If lubricant adheres to the skin or enters the eyes, follow the first aid procedure
described on the safety data sheet.