Uludag G-250, Руководство по вводу в эксплуатацию, использованию и обслуживанию

Страница: 24 / 66

22
4. ADJUSTMENTS
4.1. Cutting Angle Adjustment
Turning table can be rotated to the right- and left-hand side (CW/CCW). It could be semi-
automatically locked at 15° - 22,5° - 30° - 45° and central position 90°. To rotate the
turning table at these grades, first press and unload the lock-mechanism, then turn it untill
the desired angle is reached by holding the plastic handle on the head body on which
also the electric motor is placed, and lock at this position with the lock-mechanism. Check
whether it is fixed at exact position, by slightly rotating the head body to the right- and
left-hand side.
4.2. Installing and Replacing the Saw Blade
NOTE: Accomplish this operation, after ensuring that the machine is unplugged.
In order to install sawbladeto its place, follow the steps below:
•
Loosen the fixing screw (item no.46) and remove the upper table completely.
Disassemble the lower guard group on the head body.
•
Turn the head body into 90°-position.
•
Remove M8-25 socket-head screw (item no.51) and take the parts with item no.s
33 and 34 out.
•
Place sawbladein-between the parts with no.s 32 and 34.
•
Place the items 33 and 34 back again in turn and insert and manually tighten the
M8-25 socket-head screw (item no.51). head body
•
Assemble the lower guard group on the head body.
•
Mount the upper table and make sure that there is not any tool forgotten on the
machine.
NOTE: At the end of all these actions, you will get blade mounted on the machine.
If you're not able to manage to install blade, contact the neighbouring dealer or
Uludağ Makina via telephone or fax.
5. CUTTING
5.1. Cutting Operation
•
Loosen and undo the head body retention pin, this will cause the machine move
freely up and down.
•
Adjust the cutting angle for the work.
•
Before cutting operation, tighten and secure the work with the clamp.
•
There is a start button for electric motor on the grip, electric motor starts running
when this button is at "I" position. Wait for electric motor to build up its speed (it
takes 3-4 seconds).
•
Keep your hands off the cutting operation region.
•
Set the cutting speed. (do not use higher speeds more than necessary)
•
After finishing your cutting operation, turn the button on the grip into "O" position
and switch the machine off.
•
Do not attempt to stop sawbladewith your hands or by any other means.