Ultratec CLF2460, Руководство оператора

Страница: 7 / 10

1. Plug the Hand Remote cable into the rear connector marked remote.
2.Plug the unit into a suitable power source.
3.Turn the main power switch on and it will illuminate if power is present.
Note: For the Hand Remote to work, a valid DMX address must be set from 001 to 511.
The display goes to sleep when not in use. Touching any key once wakens it. DMX control will
override the hand remote settings. DMX control is indicated when the valid DMX light is solid RED.
4. The heat up time is approximately 8 minutes before haze can be produced. The Hand Remote indicates the
heating cycle when the haze switch light is flashing. When the unit is ready to haze the light will be solid. A
three-flash pattern and the fan turning on to full speed indicates an over temperature error. The rear panel
Green LED indicates the same status.
5. The haze rate can be switched on, off and varied by using the Hand Remote controls. Haze output increases
as the variflow knob turns clockwise.
6. The assist fan is always on low. Fan speed can be increased by rotating the fan knob clockwise. The fan
only speeds up during haze output. The Versa Fan Power Port output will also be adjusted.
5. The interval knob is used to provide cycled output. It must be set fully counterclockwise (off) when
continuous haze output is required. The hazer will produce 10 seconds of output at the requested flow, spaced
by a 1 - 300 seconds interval dependent upon the dial position.
6. 15 Minutes prior to shutting down your Radiance Hazer, adjust your haze output setting to “0” Doing this will
consume any haze fluid that is still in your distribution feed tubes and processing block. Failure to do so will
result in raw fluid being discharged from your output nozzle when you operate it next start-up and will help
reduce (not stop) the residue buildup.
Operation with Hand Remote
Haze Switch/
Heating Status LED
Variflow
Fan
Interval
Hand Held Remote (optional)
5
www.ultratecfx.com
Remote Connector
Heating Status
Green LED
DMX address must be set from 001 to 511
Versa Fan
Power Port